DesignProcessAUS
Waterproofing inspections in Australia: scope, timing, reports and cost
The value of a waterproofing inspection is not the number of photographs. It is what the project can decide after…
Insights
Expert articles on waterproofing design, compliance, testing, and remediation across Australia.
8 articles
DesignProcessAUS
Vector Mapping ELD and Electromagnetic Scanning: finding membrane breaches under overburden
A covered membrane is not impossible to test. It is harder to test well. Dry Electronic Leak Detection works best…
DesignProcessAUS
Facade water testing: investigate windows, cladding, sealants and envelope leaks
Replacing every sealant joint is not a leak investigation. Facades combine windows, glazing gaskets, pressure plates, cladding joints, sealants, flashings,…
DesignProcessAUS
Non-destructive leak detection: trace water ingress before demolition-first guesswork
The ceiling stain is evidence of water. It is not a map to the breach. Water can travel along slabs,…
DesignProcessAUS
Most waterproofing failures start before the membrane goes on
Once the membrane is installed, every substrate problem becomes harder to see and more expensive to prove. Waterproofing is often…
DesignProcessAUS
Slip resistance testing: why independent testing matters on trafficable waterproofed surfaces
A waterproofed surface can keep the level below dry and still create a problem at the surface. Balconies, podiums, exposed…